Additional Strips Anyone???

Yes, this is where you can purchase additional Strips to add the Kit you have already purchased...

Seven (7) different Colors: RED, GREEN, BLUE, ALMOST-YELLOW, TEAL, PINK/PURPLE and WHITE

You can buy additional Multi-Color Flexible Strips...

Add all the EXPLOSIVE Multi-Color  YOU WANT...

This is the one and only, Joe-Florida, bringing you another amazing Motorcycle Accent Light Kit... Nothing like it on the market...

Just "Plug" it in...

PLEASE NOTE: This is One (1) Flexible Strip and will not work by itself... You must plug this into a Multi-Color LED Accent Light Kit that you have already purchased...

The Flexible Strips are 100% waterproof...

PLEASE NOTE: This is One (1) Flexible Strip and will not work by itself... You must plug this into a Multi-Color LED Accent Light Kit that you have already purchased...

This Flexible Strip is 20 inches long and has 36-Multi-Color LEDs spaced less than 5/8 inch apart... Both ends of the Flexible Strip has connectors snaps which means NO splicing of wires... Just plug the Flexible Strip into the three (3) foot Extension Wire... This will Plug into the Kit you have already purchased...

http://www.youtube.com/watch?v=tPADnEFrqhQ

You will notice that there are connection wires at both ends of the Flexible Strips. This will allow you to cut the strip one single time in a multiple of 3 LEDs... You can install on most Cruisers a 27-LED strip under each side of the tank and a 9-LED strip behind the horn and another 9-LED strip behind the breather. A third strip can be cut into two 18-LED strips. Place one on the bottom of the oil tank or on the frame beneath the seat above the starter. The remaining 18-LED strip attached it to the frame beneath the engine for ground effects... 

Seven (7) different Colors: RED, GREEN, BLUE, ALMOST-YELLOW, TEAL, PINK/PURPLE and WHITE

1oz Tube of Silicone Sealant is included to seal all cut ends of Flexible Strips... Any Strip that you cut or that was cut at the factory must be seal after installation of the Strip. The definition of a "cut strip" is any strip with connection wire on one end and nothing on the other. The end w/o the connection wire must be sealed with Silicone Sealant after the strip is installed. 

36 LEDs in  

Seven (7) different Colors: RED, GREEN, BLUE, ALMOST-YELLOW, TEAL, PINK/PURPLE and WHITE